LogiPic - The Controls...

Back to Introduction

The three buttons are used to select the sampling rate, the trigger mode and to do a single shot trigger.

4 triggering modes are supported:

• continuous,
• Continuous wait for 0 to 1 edge on A0
• Single
• Single for 0 to 1 edge on A0

At present, the sampling rate is flat out, x1,x2,x4,x8,x16,x32,x64 or delta.

The delta mode only updates the display is the new sample is different from the last sample.

The logiPic also measures frequency on pin A4 using the Tmr0. Select Freq from the trigger menu.

To turn off the LogiPic, press the bottom and top keys untill is says Goodbye, then release both keys. The PIC is put to sleep and the LCD is not clocked and the Vlcd is removed.